Technical — Gopro

Sick of your GoPro HERO3+ or HERO4 Camera connecting to the computer as a 'Camera' vs. a drive?" Miss the old disk-drive method? Turned On by HYPOXIC's latest update forces the GoPro Camera into being a disk drive!  Update your Turned On install and it will automatically switch to "Disk Drive" mode. If you would like the "PTP / Camera Mode" just choose Advanced on the license screen. 

Below is the recommended method for plastic helmet such as the Cookie G3, Phantom X, or K.I.S.S. We like this method since it allows for quick removal if you are jumping into the wind tunnel. To remove the GoPro / Turned On Combo, it's as easy as pulling out the top pad, and sliding the cable through the hole. It literally takes less than 30 seconds.  To Install Mark directly below the cable's exit on the helmet. Using a nail or a punch, create...

Unfortunately there is no human readable settings information in the GoPro MP4 file.  However there are few bits that contain the camera's information. Hypoxic wrote a tool to extract the GoPro settings and the times of the highlight tags. This tool was made for the GoPro HERO4 but may work for older cameras. Leave feedback on HYPOXIC's Facebook page or git repository if you have suggestions.   For MAC OSx GoProInfo v. 0.0.5For PC GoProInfo v. 0.0.6 Based upon Bento4, the...

We spend a lot of time working on the interoperability between our products and GoPro Cameras. In doing this we uncover some features that may or may not make it into future products. Here are some of the bigger points: Multi Cam The camera's firmware enables multiple GoPro HERO4s to be synchronized (genlocked) to prevent inner-frame latency issues between cameras. This enables bullet-time and 360deg cubes to capture the exact same instant on all cameras. It also simplifies the post operations since...

GoPro HERO4 Session / Codname: Rocky Point Firmware version: HX1.01.01.00 (Based on GoPro HERO3+ Silver code base ARM/Thumb)Linux/ arm 2.6.38.8 Kernel Processor: Ambarella A7L_BUB (core freq: 156mhz, arm freq: 600mhz, idsp freq: 133mhz) Sensor: On Semi AR0835HS - High speed sensor supporting 8 Mp (4:3) and 6 Mp (16:9) up to 60 fpsFlash: Micron MT29F2G08ABAEA - SLC NAND Flash Parallel 3.3V 2Gbit 256M x 8bitDDR: 2GB, 377Mhz, LPDDR2 Power Management Unit: AMS AS3715 Accelerometer: bma2x2 - Bosch Sensortec MEMS accelerometerA2D: TLV320 - Automotive Catalog Stereo Audio CODEC, 8- to 96 kHz config.gz (Linux version 2.6.38.8) (See Open...