Trunk's Technical Blog

We purchased a GoPro HERO (2018) the other day and after some cursory inspection we realized this camera is actually a GoPro HERO5 with the firmware crippled. To confirm our hypothesis, we decided to trick the camera to loading the GoPro HERO5 software. It loaded properly and all the features were unlocked. Even GPS and 4K at 30fps work great! Some people were worried that we're overclocking the parts. After inspecting the device tree, we can confirm the processors and DSPs between the two...

 FOR SECURITY RESEARCH / Interoperability with our products.   The good news is the HEROBus™ is alive and well on the GoPro HERO [5-8]. The bad news is its extremely locked down and needs a BGA part and a crypto key to make it work. The needed parts are: Cypress EZ-PD CCG2 - USB type-C Controller - Accessory CYPD2104-20FNXI 20 pin $1.79 CYPD2122-20FNXI 20 pin $1.98 ATMEL ATSHA204A - Authentication Chip <- Protected! ATSHA204A-XHDA-T I2C version TSSOP $0.55 The HEROBus™ i2c Slave or Vendor...

I recently picked up the Samsung Gear Sport for the possibility of skydiving with it, tracking my daily activity, and getting notifications from my iPhone. Temptation got the best of me, and around hour one, I decided to have a look what's inside.  Disassembly of SM-R600 (Samsung Gear Sport) Overall, disassembly is easy. Just remove the four, 3-wing screws located in each corner.  The bottom pops off with a gentle pry from a spudger. Obviously, be sure to clean off both mating surfaces before closing the unit...

In this article, we dive into the GoPro HERO6 (Code named Chopes) and determined as much of the architecture as possible. Mechanically Mechanically, the GoPro HERO6 is constructed the same as the GoPro HERO5. A combination of a welded and tapped face locks out the water from the Front LCD, but allows sound to permeate to the front protected Microphone. A top and front microphone exist and sound gets channeled through a membrane. On the bottom, a sealed speaker outputs feedback beeps and...